Fipsy FPGA Pre-soldered


This board comes pre-soldered and ready to plug into your breadboard. The Fipsy FPGA Breakout Board is the perfect starter board for learning FPGA and hardware design principles. Apply the 256 LUT FPGA towards your learning and small projects! Based on the Lattice Mach XO2 FPGA, and supported with numerous examples.

Out of stock

SKU: Fipsy-v1706 Category:

Fipsy FPGA Breakout Board

  • 256 LUTs
  • Operating Supply Voltage: 3.3 V
  • Distributed RAM: 2 kbit
  • Number of Logic Array Blocks – LABs: 32
  • Maximum Operating Frequency: 269 MHz
  • FPGA Chip: LCMXO2-256HC-4SG32C
  • Ultra Low Power Devices
  • Non-Volatile, Infinitely Reconfigurable
  • Programmable by SPI and I2C
  • Based on the MachXO2 Family of FPGAs from Lattice Semiconductors
  • Onboard LED allows for simple testing
  • High Performance, Flexible I/O Buffer supports a wide range of interfaces including:
    • LVCMOS 3.3/2.5/1.8/1.5/1.2
    • LVTTL
    • LVDS
    • Bus-LVDS
    • MLVDS
    • RSDS
    • LVPECL
    • SSTL 25/18
    • HSTL 18
    • Schmitt trigger inputs, up to 0.5 V hysteresis

Manufactured by – Allied Component Works

Set-up software, and instructions can be found here: Basic Setup

Schematic: ACW17003_MAKEFPGA_X1_SCH_170622

Datasheet for the FPGA – MachX02 Datasheet


There are no reviews yet.

Be the first to review “Fipsy FPGA Pre-soldered”

Your email address will not be published. Required fields are marked *